Failure to identify who your board came from will result in a delay in repairs! After the belt is replaced or if it looks good and isn’t stretched the tray should open right away and close with a positive sounding “Clunk” as the center hub snaps up into place. Then scrape off an area of the green coating about mm square right above R7 and tin it with solder for a connection. Don’t let the drill go in too far and hit the drive. One problem is while the DVD recorder records by time such as 1, 2, or 3 hours the PC burner records in terms of file size. For some reason those tend to go bad in this model but I’m not sure why since the power supply is nearly identical to the ones used in other Samsung models that don’t have that problem.

Uploader: Kazralabar
Date Added: 26 December 2017
File Size: 35.88 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 73055
Price: Free* [*Free Regsitration Required]

It may be on the wrong side under J16, missing or stuck to the ssony of insulation. I had recorded a 2 sony dru-865s movie off TV but when I extracted the file from the track I ended up with an 8.

Drivers, Firmware & Software

The plain CH version has a very short and stiff sony dru-865s cable connecting the pc board with the moving laser carriage that can weaken from constant flexing sony dru-865s break next to the connector on the carriage. It has lots of problems with failures of the laser and pickup unit as well as various boards inside, according to the Philips chat groups.

If you see capacitors the round shiny metal cans that have tops that are swollen or have burst, like the two in the upper right, that’s a sure sign of failure! The 30 conductor ribbon sony dru-865s used sony dru-865s the CH tends to break at the end because it’s only 2″ long and rather stiff.

A replacement one 3″ long can be obtained from Mouser ElectronicsPart. I’m often son what bad capacitors look like, so here is a photo of four of them together. The power supply sony dru-865s the light colored board in the center of the cabinet with black heat sinks that the AC cord goes to at the back corner.

IsoBuster was able to save the tracks without any errors. Then scrape off an area of the green coating about mm square right above R7 and dru-865e it with solder for a connection. Sny you don’t read German use Google or Babelfish to translate, http: They have different PC boards and the burner, left, has a much bigger optical assembly on the carriage that holds the more powerful laser to burn sony dru-865s that is connected with a 50 pin ribbon cable.

You just have to remember to turn on the 12 volts for each satellite. To remove the drive from the cabinet for replacement you have to get the tray to open similar to removing a sony dru-865s disk and snap off the trim sony dru-865s on the front of sony dru-865s tray.

SONY DVD RW DRU-865S driver

I suspect it has something to do with the lack of a ground to protect it from power line surges. I punched a series of holes on the right side of the cover to let in cool air which can sony dru-865s flow over the power supply and MPEG-2 decoder heat sink to cool them before it sony dru-865s blown out the back.

After replacing C and C reverse the procedure to put it back in. Please further read our entire terms of use. Be the first to review this item. Pull each cable off carefully one at a time and replace it by pushing it down on firmly. The CH has a slot underneath sony dru-865s allow opening however. Just because the front panel power switch won’t turn the unit on doesn’t mean the front panel is bad and no matter what you do to the front panel it can’t be made to turn on a dead power supply!

It can have other problems as shown below. If your unit tends to sony dru-865s or stop playing after a few minutes you need the fan.

Apex, Digitrex, Cyberhome, Raite and LiteOn DVD Repair

The negative lead can be connected anywhere on the chassis. One problem is while the DVD recorder records by time such as 1, 2, or 3 sony dru-865s the PC burner records in terms of file size. To burn a new Sony dru-865s with Power Producer it would have taken sony dru-865s discs at full resolution so I chose the medium soby option so it would fit on one disc instead.

Most also put out but not all, so check the output with a voltmeter to make sure.

01 – 01 – Sony DRUS 22x DVD Writer

A newer model drive may be easier to find but will not sojy you any additional features such as faster speeds. Fortunately you can sony dru-865s back without a problem. To replace the board lower it down onto sony dru-865s two plastic spacers until they click in place then install the 2 screws. Besides filtering, it also has editing and a feature to remove commercials sony dru-865s TV shows but when I tried that it didn’t remove all the commercials and the resultant file wouldn’t play properly when burned on a DVD so stick with just the filtering.

Alternately L4 can be removed and mounted on the bottom of the board to make room for larger capacitors.

It might even seem like a bad power supply but is the result of dru-865e microprocessor on the decoder board not being able to cycle the power on and off correctly. Dustin Cassieia You don’t have to take the drive apart or even remove it from the PC. To change the Parental Control setting on the CH use the factory password of To download Driver Genius simply click the green “Download Now” button above or click here. If someone sony dru-865s tried to do a firmware update that failed, power supply died or for whatever reason you end up with a disc stuck in the drive and dru-685s won’t open don’t try to pry it open by force, all sony dru-865s will do is damage the bezel.

It’s difficult to determine who actually made it sony dru-865s it’s never marked on the package or sony dru-865s discs. They should always be sony dru-865s into sony dru-865s good surge protector that is grounded, such as one from APC. SO after seaching out the correct cables and waiting another week, the item would not engage or come on. Update a driver for hardware that isn’t working properly PostScript printer drivers: Pull up evenly on each side sony dru-865s it comes loose.

My only minor complaint is that it is a bit noisy. If the belt has broken or stretched out too much to drive the mechanism it won’t be possible sony dru-865s open the tray using Eject. Reset the recorder to it’s default video setting of Composite Interlaced output by pressing and holding the Stop button on the front with no disc in the tray. I also installed a toggle switch on the back under the hole where the cord comes in that is in sonu with one of the leads to make it possible to turn off the power.

At first glance the burner and player look similar, they use the same frame, same small board at the front and same disc drive motor, however The fan does not have to be mounted in a hole cut in the dru-65s since there is a sony dru-865s of air inside the unit for cooling but sony dru-865s be positioned anywhere that it can blow air over the PC board heat sinks.

It’s dru8-65s reported in TechoLiO. If the unit is accidentally switched to Progressive Scan you won’t be able to see anything on a standard NTSC TV and there’s no master reset command to set it back but it does have an undocumented Dru865s. Customer reviews There are no customer reviews yet. Sony dru-865s to install sound card drivers? Rather than having to guess and waste countless hours looking for the proper drivers to match a device with an unknown serial number – or having to deal sony dru-865s devices that can’t be recognized by your OS – Driver Genius will do all that tedious work for you sony dru-865s under 2 min.